This floral bow door swag gives off such a warm, welcoming feel for summer! A beautiful floral bow design with pink wispy flower stems surrounding a gorgeous Bowdabra summer bow! And the best part, you wouldn’t believe how easy it is to create using the Bowdabra!
Floral Bow Door Swag
Let’s get started by gathering the following materials:
Then, fold a 36″ piece of Bowdabra wire in half and lay in the Bowdabra, You’ll have a loop at one end and two loose pieces at the opposite end and tuck ends under.
To make the floral bow:
You will first need to bend the stem ends of the wispy flowers left or right to spread the branches around the Bowdabra as you insert them. Then place different lengths of flower stems down into the Bowdabra with shorter branches on top and sides, and larger stems hanging down towards the bottom.
Next, crease the end of the wired ribbon and place down into the Bowdabra.
Make a 5″ loop on one side and place the ribbon down into the Bowdabra
Since the plaid design is on both sides fold the other side at the same 5″ width for the next loop, creasing the ribbon down into the Bowdabra.
Continue to make loops on each side until you’re satisfied with the look. I made a total of ten loops, five on each side. Then scrunch down the ribbon using the Bowdabra Wand.
Make a slip knot by taking the loose ends of the bow wire through the wire loop, pulling tight while gently pulling the bow out. Separate the wires around to the back, tying in a double knot.
Next, pull the bow wire through floral foam using floral wire shaped into a “U.” Make a loop for hanging and secure with a floral pin and seal with hot glue.
Fluff the bow and it’s ready to hang!